Rear Panel - Roland EQ-131 Owner's Manual

2 Rear Panel
<EQ-131>
<EQ-215>
1 2 3 4 5 4 3
CHANNEL B | CHANNEL A
<EQ-231>
1 INPUT: Input Jacks
These inputs are stereo phone jacks compatible with balanced
input. (Rated Input Level = +4 dBm)
* In case of unbalanced input by phone jack, output level drop
6 dB.
2 INPUT: Input Connectors
These inputs are XLR connectors compatible with balanced
input. (Rated Input Level = +4 dBm)
3 OUTPUT: Output Jacks
These outputs are stereo phone jacks compatible with balanced
output. (Rated Output Level = +4 dBm)
4 OUTPUT: Output Connectors
These outputs are XLR connectors compatible with balanced
output. (Rated output Level = +4 dBm)
10
CHANNEL B | CHANNEL A
CHANNEL A —
ATTENTION.
2 1
5 LOW CUT: Low Cut Filter Control Knob
(only EQ-131/215)
This knob sets the cutoff frequency (10 Hz - 250 Hz: the
frequency at which the effect starts) for the low-cut filter. This
will be cut -12 dB/octave.
6 FUSE: Fuse Holder
* When replacing the fuse, use only the specified
type and size (0.5 A/250 V). And always turn the Q
unit off and unplug the power cord before
replacing the fuse.
The pin configuration of the inputs and outputs is as follows.
Before making connections, make sure of the pin
configuration for the devices being connected.
HOT O——
coLD o^ 1
GROUND