Maintenance; Troubleshooting - Husqvarna Xcite 60 Operator's Manual

Introduction
WARNING:
maintenance work you must read and
understand the safety chapter.
Maintenance schedule
* = The instructions are not given in this operator's
manual.

Maintenance

Make sure that the nuts and screws are
tightened.
Clean the product.
To clean the product
• Use a brush to remove unwanted material and
grass on the product.
Troubleshooting schedule
If you cannot find a solution to your problems in this
operator's manual, speak to your Husqvarna service
agent.
Problem
Unusual vibrations or noise.
2225 - 001 - 02.10.2023
Maintenance
Before you do any
Daily mainte-
Before use

Troubleshooting

Cause
Loose or missing screws or nuts.
X = The instructions are given in this operator's
manual.
O = Refer to the engine manual for instructions.
Maintenance schedule for the operator
Maintenance interval in hours
nance
5
X
• If it is necessary, use a high-pressure washer
and a weak cleaning agent. Do not exceed 1000
psi (68.9 Bar) water pressure.
25 50
X
7