Installation; Operation - Husqvarna Xcite 60 Operator's Manual

Introduction
WARNING:
the safety chapter before you install the
product.
To install the mulch kit
WARNING:
cutting deck are sharp and can cause
injury. Use protective gloves.
1. Raise and support the mower.
2. Remove the old blade bolts, washers and cutting
blades.
3. Align the left and right debris baffle with the holes
in the underside of the cutting deck. Tighten the
9 bolts and locking nuts.
Introduction
WARNING:
product, you must read and understand
the safety chapter.
To operate the product
• Obey the operation instructions in the Operator's
manual for the mower.
6

Installation

Read and understand
The blades on the

Operation

Before you operate the
4. Install the cover. Use the thumb screws and u-
clips.
5. Install the new spacers, mulch blades, large
washers, locking washers and bolts.
6. Remove the supports and lower the mower to its
normal position.
• Move the product forward at low speed to get a
good cutting result.
• Cut the grass 2 times if the grass is high and
thick. The first cut must be at the highest cutting
height and the second time at the correct height.
• Do not cut a wet lawn.
2225 - 001 - 02.10.2023