Programmable Band-Scan Limits - Yaesu FT-1802M Operating Manual

P
Besides band and memory scanning, this transceiver can be set to tune or scan only the
frequencies between user-defined lower and upper limits. For example, you may wish to
limit tuning/scanning to 144.3 - 148.0 MHz, to avoid encroachment on the SSB/CW sub-
band between 144.0 and 144.3 MHz
These scanning limits are stored in special "Sub-Band Limit Memories," labeled L0/U0
through L9/U9, with "L" and "U" designations representing the Lower and Upper limits,
respectively.
To utilize this feature, use the following steps:
1. Store the lower edge of the desired scanning/tuning range in memory "L0", and the
upper edge in memory "U0" (or, alternatively, in memories "L1/U1" through "L9/U9").
2. With any of these memories recalled, press the [ MHz ( SET )] key momentarily to acti-
vate the Programmable Band-Scan Limits. The "PMS" icon will appear. Tuning and
scanning will now be limited within the just-programmed range.
To cancel the Sub-Band Limits and return to normal memory operation, press the [ D/
MR ( MW )] key momentarily.
Do not attempt to initiate "normal" scanning on any of the PMS memory chan-
nels. If you do, an error message will result; the "U/L" memories are dedicated
for the establishment of band scanning limits.
FT-1802M O
ROGRAMMABLE
M
B -S
AND CAN
S
CANNING
L
IMITS
47