Break-In And Operation - Cub Cadet 3654, 3660 Operator's And Service Manual

25 horsepower hydrostatic zero-turn commercial riding mower
Hide thumbs Also See for 3654, 3660:
Table of Contents

Advertisement

the left hand side. (NOTE: Be sure the blades are parallel to
the frame rails of the unit when taking paved surface to
blade edge measurements.)
b.
If the left hand side is within 1/4" of the right hand side no
more adjustment is necessary.
c.
If the left hand side is higher than the right hand side by 1/4",
increase both eyebolt lift link lengths on the left hand side
until the left side is within 1/4" to the right hand side. Tighten
all nuts loosened. (NOTE: Since the proper angle of the deck
has already been established, the eyebolt lift link lengths in
the left rear and left front of the deck must have equivalent
adjustment. The proper angle will be lost if only the one eye-
bolt lift link is adjusted or if the rear and the front eyebolt lift
links are not adjusted the same.)
d.
If the left hand side is lower than the right hand side by 1/4",
decrease both eyebolt lift link lengths on the left hand side
until the left hand side in within 1/4" to the right hand side.
Tighten all nuts loosened. (NOTE: Since the proper angle
of the deck has already been established, the eyebolt lift
link lengths in the left rear and left front of the deck must
have equivalent adjustment. The proper angle will be lost if
only the one eyebolt lift link is adjusted or if the rear and the
front eyebolt lift links are not adjusted the same.)
C. Break-In And Operation
1.
Start the Engine:
a.
Open the fuel shutoff valve.
b.
Sit on the Seat. Set the parking brake "On".
c.
Move the left and right steering levers to the neutral,
opened-out position.
d.
Turn the electric blade clutch switch "Off".
e.
Push the throttle control to a position a third of the way
between slow and fast.
f.
Insert the key in the ignition and start switch and turn the
switch to "On".
g.
Gasoline Engine: If the engine is cold, push the choke to
the on position.
h.
Turn the ignition key in a clockwise direction to the "Start"
position until the engine starts.
DANGER:
Reread the "When Mowing" Safety Precautions.
12

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents