Advertisement
2
PREPARATION BEFORE USE
Preparing Filters
1. Open the air inlet grille and remove the air fi lters.
2. Attach the fi lters. (see detail in the accessory sheet).
Loading Batteries
1. Remove the battery cover.
2. Insert 2 new batteries (AAA type)
following the (+) and (–) positions.
Clock Setup
•
1. Push CLOCK
by tip of the pencil.
If timer indication is fl ashing, go to the next step 2.
2. Press
ON
or
OFF
: adjust the time.
3. Press
: Set the time.
Remote Control Reset
1. Remove the battery.
2. Press
.
3. Insert the battery.
3
AIRFLOW DIRECTION
Press
: Move the louver in the
1
desired vertical direction.
Press
: Swing the air
2
automatically and press again to stop.
For horizontal direction, adjust
3
manually.
Note:
• Do not move the louver manually by others.
• The louver may automation positioning by some operation mode.
4
REMOTE CONTROL
1
Infrared signal emitter
2
Start/Stop button (
)
3
Mode select button (
)
4
Temperature button (
)
5
Fan speed button (
)
6
Swing louver button (
)
7
Set louver button (
)
8
On timer button (
ON
)
9
Off timer button (
)
OFF
!
Sleep timer button (
)
"
Setup button (
)
#
Clear button (
)
$
Memory and Preset button (
)
%
High power button (
)
&
Economy button (
)
(
Filter reset button (
)
)
Clock Reset button ( )
~
Check button (
)
Note: Some models, remote will have text above
the buttons.
5
AUTOMATIC OPERATION
To automatically select cooling or fan only operation
1. Press
: Select A.
2. Press
: Set the desired temperature.
Carrier 1110650132 (01_EN).indd 4
Carrier 1110650132 (01_EN).indd 4
6
1. Press
2. Press
3. Press
7
For dehumidifi cation, a moderate cooling performance is controlled
automatically.
8
To automatically control room temperature and airfl ow for faster cooling
operation (except in DRY and FAN ONLY mode)
9
To automatically control room to save energy (except in DRY and FAN ONLY
mode)
Note: Cooling operation; the set temperature will increase automatically 1 degree/
10
In case of the misplaced or discharged remote control
1
11
Set the timer when the air conditioner is operating.
5
$
4
3
2
%
6
&
7
#
Daily timer allows the user to set both the ON & OFF timers and will be
8
9
ON
OFF
activated on a daily basis.
!
"
~
(
)
Note:
COOLING / FAN ONLY OPERATION
: Select Cool
or Fan only
: Set the desired temperature.
Cooling: Min. 17
o
C, Fan Only: No temperature indication
: Select AUTO, LOW , LOW+
or HIGH
.
DRY OPERATION
1. Press
: Select Dry
.
2. Press
: Set the desired temperature.
Hi-POWER OPERATION
Press
: Start and stop the operation.
ECO OPERATION
Press
: Start and stop the operation.
hour for 2 hours (maximum 2 degrees increase).
TEMPORARY OPERATION
• Pressing the RESET button, the unit can start or
stop without using the remote control.
• Operation mode is set on AUTOMATIC operation,
preset temperature is 24°C and fan operation is
automatic speed.
TIMER OPERATION
Setting ON Timer
Press
Press
: Set the desired ON
1
ON
timer.
2
Press
: Set the timer.
Press
Press
: Cancel the timer.
Press
3
Setting Everyday Timer
1
3
Press
ON
: Set the ON timer.
Press
: Set the OFF
2
OFF
4
timer.
• During the every day timer is activating, both arrows ( , ) are indicated.
• Keep the remote control in accessible transmission to the indoor unit;
otherwise, the time lag of up to 15 minutes will occur.
• The setting will be saved for the next same operation.
.
, MED
, MED+
,
Setting OFF Timer
: Set the desired OFF
OFF
timer.
: Set the timer.
: Cancel the timer.
Press
.
Press
button during the
( or ) mark fl ashing.
10/2/09 10:55:43 AM
10/2/09 10:55:43 AM
Advertisement
