Windows 2000/Xp (Without Xp Service Pack 2); Windows Xp (With Service Pack 2) - National Instruments PXI-8310 User Manual

Chapter 2 Hardware and Software Installation
NI CardBus-8310-to-PXI Expansion User Manual

Windows 2000/XP (Without XP Service Pack 2)

1. If you do not have your system configured to allow autorun CDs, you
must run
SETUP.EXE
2. Follow the prompts to install the software.
3. When the software prompts you reboot, do so. When the system has
been rebooted, the installation process is complete.

Windows XP (With Service Pack 2)

1. If you do not have your system configured to allow autorun CDs, you
must run
SETUP.EXE
After the software setup utility launches, the dialog box shown in
Figure 2-1 will appear.
Figure 2-1. Software Installation Dialog Box
2. The driver will make a small change to
you to reboot, as shown in Figure 2-2. You must do this before the
driver install can continue.
to install the NI CardBus-8310 driver.
to install the NI CardBus-8310 driver.
2-2
, and then prompt
boot.ini
ni.com