Table of Contents
Advertisement
a. Flex both sides of the bracket to remove the 2.5-inch storage drive from the bracket.
Figure 54. Removing the 2.5-inch storage drive from the bracket
1
b. Pivot the tab
the adapter slide into the notches
from the converter.
Figure 55. Removing the adapter from the converter
c. Flex both sides of the adapter to release the four pins
storage drive from the adapter.
Figure 56. Removing the storage drive from the adapter
5. To install a new 2.5-inch storage drive, do the following:
118
P330 Hardware Maintenance Manual
of the metal adapter upward. Then, push the adapter as shown until the four tabs on
2
. Pivot the adapter as shown to remove it with the storage drive
1
from the storage drive. Then, remove the
Advertisement
Table of Contents
