Table of Contents
Advertisement
b. Locate the hole in the plastic holder to install the retention latch. Align the pin
corresponding hole
until it snaps into position.
Figure 30. Installing the retention latch
c. Hold the new M.2 solid-state drive by its edges and ensure that the circuit board side is facing
upward. Align the contact edge of the new drive with the key in the corresponding slot. Then carefully
insert the new drive into the slot at an angle of about 20 degrees and pivot the new drive downward.
Insert the plug of the retention latch into the hole to secure the new drive.
Note: Do not touch the circuit board of the M.2 solid-state drive.
Figure 31. Installing the M.2 solid-state drive
106
P330 Hardware Maintenance Manual
b
in the plastic holder. Then press the retention latch downward into the hole
a
with the
Advertisement
Table of Contents
