Table of Contents
Advertisement
Setup and Operation Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section
at the beginning of this manual including all text under
subheadings therein before set up or use of this product.
TO PREVENT SERIOUS INJURY:
Before loading or unloading turn vehicle's engine off, set its transmission
in gear or park, engage its emergency brake and block its wheels.
Make sure the Ramp is completely open and the securing
chains and hooks are secured to the vehicle. Make sure the
Ramp is clean and dry before loading or unloading.
Setup
1.
Make sure the tailgate the Ramp
will sit on is dry and clean.
2.
Check for and tighten any
loose hardware.
Warning!
Tailgate must not be higher
than 36". The lower the tailgate the
safer loading and unloading will be.
3.
Sit the tongue (angled lip) of the
Ramp on the tailgate. The Tongue
Edge must face down and fully
contact the truck's tailgate.
4.
Extend the Safety Chain on each
side of the Ramp up into the inside
of the truck bed; attach each Safety
Chain to a secure attachment
point on the truck chassis.
Chain Adjustment
1.
Remove the bolt and washer that
hold the safety chain to the Ramp.
2.
Reinsert the bolt through a link that
will shorten the chain so the loading
Ramp can not be pulled backwards
more than an inch or two.
Page 4
For technical questions, please call 1-888-866-5797.
WARNING! CONNECT SAFETY CHAINS
TO SECURE ATTACHMENT POINTS
WITHIN THE TRUCK BED ABLE TO
WITHSTAND THE PULLING FORCE
OF LOADING. THEY MUST ALSO
BE TAUT ENOUGH TO PREVENT
THE RAMP FROM COMING OFF
THE VEHICLE BEING LOADED.
5.
Pull the loading Ramp back until
the chains are tight. The entire
tongue portion of the Ramp must
fit onto the tailgate; if not, adjust
the Safety Chains accordingly, or
shorter chains must be used.
3.
Make sure that the bolt is properly
tightened and the washer prevents the
bolt from slipping through the chain link.
4.
Adjust the other chain to equal length.
Item 94057
Advertisement
Table of Contents
