Xerox Phaser 8200 Networking Setup Manual page 42

14. Select the Network Card tab. A new dialog box is brought to the front and displays information
about frame type and connectors.
15. Be certain the printer is enabled and the connector and frame type are correct.
16. If any changes are made, reset the printer from the front panel.
17. Run a test print again. If the test print does not print, refer to the Xerox web site at:
www.xerox.com/officeprinting/support.
Phaser® 8200 Color Printer
Novell NetWare 3.x/4.x/5.x Network
37