Steps
1. Place the power-adapter port into the slot and adhere the power-adapter port cable on the system board.
2. Connect the power-adapter port cable to the system board.
3. Place the power-adapter port bracket on the power-adapter port and align the screw holes on the power-adapter port
bracket to the screw holes on the palm-rest and keyboard assembly.
4. Replace the two screws (M2x5) that secure the power-adapter port bracket to the palm-rest and keyboard assembly.
Next steps
1. Install the
rear
cover.
2. Install the
base
cover.
3. Follow the procedure in
System board
Removing the system board (Single-color keyboard)
NOTE:
This procedure is applicable only for computers that are shipped with a single-color keyboard.
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
3. Remove the battery.
4. Remove the
rear
cover.
5. Remove the
solid-state
6. Remove the
wireless
card.
7. Remove the
memory
module.
64
Removing and installing Field Replaceable Units (FRUs)
After working inside your
Before working inside your
drive.
computer.
computer.