Assembly - Snapper 1690393 Operator's Manual

Assembly
ATTENTION SETUP PERSONNNEL:
As setup personnel you have an obligation to know the
product better than the customer. This includes safety
related items. Prior to actual setup, thoroughly familiar¬
ize yourself with the Operator's Manual. Pay special
attention to all safety warnings. It is possible during setup
to place yourself in a position which is more hazardous
than when the unit is in operation. Remember, it is your
responsibility to set up the product safely and to know it
well enough to be able to instruct a customer in the safe
use of his power unit.
Safety is a matter of common sense ... A matter of
thinking before acting. Most shops have specific safety
practices. Follow them. The precautions listed in the
Operator's Manual should not supersede existing prac¬
tices but should be considered as supplemental informa-
tion._
Use the following procedure to install the parts shipped
loose.
PULLEY & BELT STOP
Install power take-off pulley (item F, figure 9) and belt
stop (item B) on tractor as follows:
1. Install a key in key way of transmission input shaft
(item E). Slip power take-off pulley (item F) over
key and shaft with setscrew in pulley hub on
inboard side. Be sure pulley and key are flush with
the end of the shaft. Then tighten setscrew in
pulley hub.
2. Reach up through slot above pulleys and insert
clip (item A) into hole in tractor frame above
power take-off pulley.
Figure 9. Install Belt Stop
A. Clip, Tinnerman D. Capscrew
B. Belt Stop E. Shaft
C. Flat Washer F. Power Take-Off Pulley
3. Install belt stop (item B), washer (item C) and
capscrew (item D) so that belt stop curves over
front of power take-off pulley. Tighten capscrew
at this time only if you intend to run tractor
without installing tiller.
INSTALL PULLEY ITEMS
Install pulley items (figure 10) at rear of tractor as
follows:
1. Raise seat deck and remove tractor battery. (Refer
to tractor manual.)
2. Install capscrew (item C) through hole in back of
battery compartment and upper hole of pulley
support bracket (item I). Then loosely install
lockwasher (item M) and nut (item L) on this
capscrew.
3. Install idler pulley (item F) on pulley bracket (item
H). Use a capscrew (item G), spacer (item E), two
washers (item N), lockwasher (item B) and nut
(item A) to secure pulley.
4. Reach through hole in rear of tractor and place
pulley bracket (item H) on inside wall. Insert
capscrews (item D) through holes in pulley brack¬
et, wall and pulley support bracket (item I). Then
install lockwashers (item J) and nuts (item K).
5. Tighten all three nuts (items K and L) to secure
pulley support bracket (item I).
6. Reinstall battery and lower seat deck.
Figure 10. Install Pulley Items
A. Nut H. Pulley Bracket
B. Lockwasher I. Pulley Support Bracket
C. Capscrew J. Lockwashers (two)
D. Capscrews (two) K. Nuts (two)
E. Spacer L. Nut
F. Pulley M. Lockwasher
G. Capscrew N. Washer
8