Dometic CD20 Service Manual page 19

Refrigerators
21 Arranging the Thermostat
10. Arrange the new thermostat as shown in Figure 21.
11. Complete these steps in reverse order to install the
new thermostat assembly, ensuring that:
– Hot-melt glue or other adhesive is applied to
the locations where the glue was removed (the
mastic compound can be retained from the old
thermostat and reused, if present).
– The wiring harness is pulled through the loop of
the sensing probe before making the electrical
connections.
7 .10 .3 Replacing CD Series Thermostat
Assemblies
22 Removing the Drawer
1. Slide the drawer out until the rails reach full extension.
2. Push the lever down on the right side of the rail and
gently lift on the left side to remove the drawer.
EN
23 Removing the Thermostat Assembly
3. Locate the thermostat assembly, which is located
inside of the unit on the right-hand wall.
4. Remove the two #2 Phillips-head screws securing the
thermostat assembly to the interior of the unit.
24 Disconnecting the Thermostat Assembly
I Handle the capillary tubing attached to the
thermostat carefully to ensure that it does not
become bent or kinked.
Service Procedures
19