Nimh/Nicd Program; Pb Lead-Acid Program - HITEC RDX2 800 Operation Manual

NiMH/NiCd PROGRAM

From the main menu, press the scroll button to enter the Charger's settings.
1
SELECT BATTERY TYPE
Using the scroll wheel, select the
type of battery connected.
Battery Type
LiPo
Lilo
LiFe
LiHV
NiMH
Press scroll wheel NiCd
Pb
to confirm.
3
SELECT TASK
Using the scroll wheel, select the charge
mode. LiPo Balance is recommended.
Charge
Re-Peak
CYCLE_C_D
Task
CYCLE_D_C
Press scroll wheel
to confirm.
5
SELECT CURRENT
Using the scroll wheel, select the charge current.
1C charge rate is recommended.
(IE 500mAh = 5.0A)
0.1A
Press scroll wheel
0.2A
to confirm.
Current
19.9A
20.0A
20
2
SELECT BATTERY CELL
Using the scroll wheel, select the
cell count of the battery connected.
4S
Battery Cell 5S
Press scroll wheel 14S
15S
to confirm.
4
SELECT CONDITION
Using the scroll wheel, select the delta voltage.
The default is -6mV, recommended to skip.
Press scroll wheel
-3mV
to confirm.
-4mV
-5mV
-6mV
Condition
-7mV
-8mV
-9mV
6
START/STOP
Using the scroll wheel, select Start
and press to initiate the charge
process using the selected settings.
Start
Press the scroll button again to stop the
charge process and return to settings.

Pb LEAD-ACID PROGRAM

From the main menu, press the scroll button to enter the Charger's settings.
CH A CHARGE SETTING
Battery Type
Battery Cell
Task
Condition
Current
Start
Back
1
SELECT BATTERY TYPE
Using the scroll wheel, select the
type of battery connected.
Battery Type
Lilo
LiFe
LiHV
NiMH
Press scroll wheel NiCd
Pb
to confirm.
3
SELECT TASK
Using the scroll wheel, select the
charge mode.
Normal
AGM Charge
Task Cold Charge
Discharge
Press scroll wheel
to confirm.
5
SELECT CURRENT
Using the scroll wheel, select the
charge current.
Press scroll wheel
0.1A
to confirm.
0.2A
9.9A
Current
10.0A
Pb
6S(12.0V)
AGM Charge
2.45V
5.0A
2
SELECT BATTERY CELL
Using the scroll wheel, select the
cell count of the battery connected.
3S
Battery Cell 6S
12S
Press scroll wheel
to confirm.
4
SELECT CONDITION
Using the scroll wheel, select the end voltage.
Only available in discharge mode.
Press scroll wheel
1.80V
to confirm.
1.90V
2.00V
Condition
6
START/STOP
Using the scroll wheel, select Start
and press to initiate the charge
process using the selected settings.
Start
Press the scroll button again to stop the
charge process and return to settings.
21