Nimh/Nicd Battery Program - HITEC X4 AC Pro Instruction Manual

Lithium Battery Program (continued)
Program Stop
During the charging process, press STOP button to stop the process.
Program Complete
[ END: FINISH ]
When the discharging process is nished, an audible
66
12.60V 02001mAh
sound will be heard and the charger will indicate
TIME: 00:32:15
END: FINSHED. The charger displays the total pack
66
12.60V 02001mAh
voltage, total mAh drawn from the battery and the
elapsed time of the process.
NOTE: The battery charge indicator displays
during discharging.
Other Information Displayed During the Process
Pressing the INC or DEC buttons during the charging or discharging process al-
lows you to see a variety of other information on the screen.
End Voltage
Final voltage at the end of the program.
12.6V (3S)
IN Power Voltage
Input voltage from internal or external power source.
14.82V
Ext. Temp ----
Internal and external temperatures. External Tempera-
Int. Temp 37°C
ture requires optional temperature sensor. #44159
Temp Cut-Off
Cut-o temperature when using external temperature
50°C
sensor.
Safety Time
Safety timer ON and duration of time in minutes.
ON 120min
Capacity Cut-Off
Capacity cut-o ON and set value of the capacity limit.
ON 5000mAh
22
Green Red
during charging and
NiMH / NiCd Battery Program
This program is only suitable for charging/discharging NiCD/NiMH batteries. The
X4 AC Pro o ers the following NiCD/NiMH charge modes: Charge, Auto Charge,
Discharge, Re-Peak and Cycle.
Whenever a parameter value in the program needs to be adjusted, highlight
the value by pressing the START/Enter button to make it blink; to change the
value press the DEC or INC buttons. The new value will be stored by re-pressing
the START/Enter button. If there is another parameter to be adjusted as part of a
range on the same screen, it will start blinking after the rst parameter value has
been con rmed.
BEFORE YOU BEGIN CHARGING YOUR BATTERY, MAKE SURE YOU
HAVE READ AND UNDERSTAND ALL OF THE WARNINGS AND SAFETY
Warning INFORMATION CONTAINED ON PAGES 3 7.
BEFORE SELECTING A CHARGE MODE, IT IS CRITICAL THAT YOU SELECT
THE CORRECT TYPE OF BATTERY TO BE CHARGED. FAILURE TO DO SO CAN
Warning
RESULT IN DAMAGE TO THE BATTERY AND POSSIBLE EXPLOSION.
BATT/PROGRAM Select
BATT/PROGRAM
NiMH BATT
Press INC and DEC to cycle through the battery types
and press START/ENTER to select the appropriate
battery type to be charged.
NiMH / NiCd Charge Mode:
NiMH CHARGE
Press INC and DEC to scroll to Charge Mode. Press the
CURRENT 2.0A
START/ENTER button to con rm.
NIMH CHARGE
Setting the Charge Current
CURRENT 2.0A
Press INC and DEC to increase or decrease the charge
current. Press the START/ENTER button to con rm the
setting. The rate can be adjusted from 0.1 ~ 10A.
SETTING A CHARGE CURRENT THAT IS TOO HIGH CAN HAVE DAN-
GEROUS RESULTS. NEVER EXCEED THE BATTERY MANUFACTUR-
Warning
ERS RECOMMENDED CHARGE RATE
23