Table of Contents
Advertisement
10-Troubleshooting
Problem
Automatic adjust-
ment of washing time.
Spinning fails.
Unsatisfactory wash-
ing result.
Washing powder
residues are on the
laundry.
Laundry has grey
patches.
Note: Foam formation
If too much foam is inspected during spin cycle, motor stops and drain pump will be ac-
tivated for 90 seconds. If that elimination of foam fails up to 3 times, programme ends
without spinning.
Should the error messages reappear even after the taken measures, switch off the appli-
ance, disconnect the power supply and contact the customer service.
10-1
Note: Unlock the door
When the washing machine in a safe state (under the water level below the window
along a certain distance, barrel temperature below 55 °C, the inner barrel did not turn),
may unlock the doors of the machine operation.
28
Cause
• Washing programme duration will
be adjusted.
• Unbalance of laundry.
• Degree of pollution does not agree
with selected programme.
• Detergent quantitiy was not suf-
fi cient.
• Maximum load has been exceeded. • Reduce loading.
• Laundry was unevenly distributed
in the drum.
• Insoluble particles of detergent can
remain as white spots on the laun-
dry.
• Caused by fats such as oils, creams
or ointments.
10.4 In case of power failure
The current programme and its setting will be saved.
When power supply is restored operation will be re-
sumed.
If a power failure cuts an operating wash programme
A
door opening is mechanically blocked. To get out any
laundry water level should not be seen in the glassy
porthole of the door - Danger of burns! Water level has
to be lowered as described in "Pump fi lter". Not till then
pull lever (A) beneath service fl ap (Fig. 10-1) until door
is unlocked by a gentle click. Afterwards refi x all parts.
Solution
• This is normal and doesn't af-
fect functionality.
• Check machine load and laundry and
run a spinning programme
• Select an other programme.
• Choose the detergent acc. to
the degree of pollution and acc.
to manufaturer specifi cations.
• Loose the laundry.
• Perform extra rinse.
• Try to brush the points from
the dry laundry.
• Choose an other detergent.
• Pretreat the laundry with a
special cleaner.
EN
again.
Advertisement
Table of Contents
