Table of Contents
Advertisement
Refilling salt
When the refill reminder
appears in the display, wait until the
end of the programme and then refill
the salt reservoir.
Confirm with OK.
The salt refill indicator will go out.
Risk of corrosion due to saline
solution.
Saline solution that runs out can
cause corrosion in the wash cabinet
and to the load items.
Immediately after filling the salt
reservoir and each time you remove
the salt reservoir cap, run the
programme without load items in
salt
the dishwasher to dissolve and re-
move any traces of salt from the
wash cabinet.
Before using for the first time
After the salt reservoir has been filled,
the salt refill indicator may still appear
Refill salt
on the display if the salt concentration
has not yet reached the correct level. In
this case, confirm the message again
with OK.
The salt refill indicator will be switched
off if you have programmed the dish-
washer for a water hardness below
0.9 mmol/l (5 °dH – German scale).
Rinse
29
Advertisement
Table of Contents
