Additional Functions - HELIX V EIGHTEEN DSP User Manual

Additional functions

1. SCP (Smart Control Port)
This multi-functional input is designed for
HELIX V EIGHTEEN DSP accessory prod-
ucts like a remote control which allows to ad-
just several features of the amplifier. Depend-
ing on the type of remote control, at first its
functionality has to be defined in the " Device
Configuration Menu" of the DSP PC-Tool soft-
ware.
Attention: If the accessory product does not
have a NanoFit connector, a SCP-to-Control
Input adaptor (Art-Nr. M141313) is optionally
available from your specialist dealer.
SCP-to-Control Input adaptor
2. Control pushbutton
The V EIGHTEEN DSP provides 10 inter-
nal memory locations for sound setups. The
Control pushbutton allows the user to switch
between two memory positions. These can be
defined in the DSP PC-Tool. In addition a de-
vice reset can be made by pressing the button
for a longer period.
1. Setup switch: Press Control pushbutton for
1 second. The memory locations one and two
are defined by default. Switching is indicated
by a single red flash of the Status LED. Al-
ternatively, the optional URC.3 remote control
can be used for switching. To switch between
all internal memory locations, optional acces-
sories like the DIRECTOR display remote
control or CONDUCTOR are required.
2. Device reset: Press pushbutton for five
seconds. This completely erases the internal
memory and is indicated by a continuous red
glowing and constant green flashing of the
Status LED.
Attention: After erasing the setups from
memory the V EIGHTEEN DSP will not re-
produce any audio output until the device is
updated via the DSP PC-Tool software.
3. Status LED
The Status LED indicates the operating mode
of the amplifier and of its memory.
Green: Amplifier is ready for operation.
Orange: Power Save Mode is active.
Red: Protection Mode is active. This may
have different root causes. The HELIX
V EIGHTEEN DSP is equipped with protec-
tion circuits against over- and undervoltage
as well as overheating. Please check for con-
necting failures such as short-circuits or other
wrong connections. If the amplifier is over-
heated the internal temperature protection
switches off the remote and signal output until
it reaches a safe temperature level again.
Red / green slow flashing: No operating soft-
ware installed. Connect the amplifier to the
DSP PC-Tool software and confirm the au-
tomatic update of the operating system. You
will find the latest version of the DSP PC-Tool
software at www.audiotec-fischer.com.
Red / green fast flashing: The currently se-
lected sound setup memory is empty. A new
setup has to be loaded via the DSP PC-Tool
software or switch to a memory position with
existing sound setup.
en
29