Top Tray; Stacker Tray; Stapling - Xerox DocuPrint 75 Installation Planning Manual

Product overview
5-6
Figure 5-6. Finisher components
Stapler is within
the finisher

Top Tray

The Top Tray holds up to 250 prints.
The top tray is inherent to the design of the inverter. If a sheet is
too short, it will be sent to the top tray when completed.

Stacker Tray

The Stacker Tray is the output tray for all other jobs. The Stacker
Tray has two staplers, each with a 5000-staple cartridge, that
can staple sheets ranging in size from 6.7 x 8 inch (170 x 203
mm) to 12 x 18 inch (305 x 457 mm) of 16 to 110 lb. (60 to 200
gsm) stock. Up to a maximum of 50 sheets of 20 lb. (80 gsm) can
be stapled.

Stapling

Removing any of the output while the printer is running may
produce finished sets that are incorrectly stapled.
To ensure that the stapling of thin sets is satisfactory, the printer
performs the following actions.
Installation Planning Guide
Top Tray
Press the Finisher Button to
unload the Stacker Tray during a
print run
DocuTech/DocuPrint 75/90 and DocuPrint 75 MX
Finisher
button