Xerox DocuColor 2045 Color Management Manual page 31

Color Management Guide
In this set-up, you add any Non-Xerox stocks you wish to print on
to one of the three groups.
• Bright White (Greater than 95)
• White (93.7 > L* <= 95)
• Other (L* <= 93.7)
NOTE: White point values can be found on the ream wrapper
and/or from the manufacturer.
Key Points to this approach:
• Accounts for the various whiteness in a stock mix.
• Limits calibration to only three stock types.
• Recommended for most workflows.
• Requires three stock calibrations instead of one (Unspecified
Model).
Adding a Xerox Qualified Stock:
1. Select [Printer Manager: Stock Library: Stock Catalog].
2. Select a Xerox stock and add the stock from the Stock
Catalog to the Stock Library.
3. Select your stock in Printer Manager and calibrate if required.
NOTE: The pre-installed stocks have 1 of 3 stock profiles: Bright
White, White, or Other, based on their color group.
Adding New Stock: Non-Xerox:
1. Select Printer Manager: New Stock.
2. Add your custom name.
3. Select the color group, if a group other than the default group
is desired.
4. Your new stock will automatically pick up the calibration of the
group.
NOTE: Keep in mind, if any other stock with the same whiteness
group has been calibrated, then this new stock will automatically
acquire the group's calibration.
NOTE: On iGen3, custom stock will be created at the Press
Interface and will always be automatically part of the default
group. You can move the stock to another group at the DocuSP
controller.
Stock Management and Calibration
3-9