Choosing A Connection Method; Connecting Via Ethernet (Recommended) - Xerox Phaser 8560 User Manual

Choosing a Connection Method

Connect the printer via Ethernet or USB. A USB connection is a direct connection from the
printer to your computer and is not used for networking. An Ethernet connection is used for
networking. Hardware and cabling requirements vary for the different connection methods.
Cabling and hardware are generally not included with your printer and must be purchased
separately.
This section includes:
■

Connecting via Ethernet (Recommended)

■ Connecting via USB
Connecting via Ethernet (Recommended)
Ethernet can be used for one or more computers. It supports many printers and systems on an
Ethernet network. An Ethernet connection is recommended because it is faster than a USB
connection. It also allows you direct access to CentreWare Internet Services (IS). The
CentreWare IS web interface enables you to manage, configure, and monitor networked
printers from your desktop.
Network Connection
Depending on your particular setup, the following hardware and cabling is required for
Ethernet.
■ If you are connecting to one computer, an Ethernet RJ-45 crossover cable is required.
■ If you are connecting to one or more computers with an Ethernet hub, cable, or DSL
router, two or more twisted-pair (category 5/RJ-45) cables are required. (One cable for
each device.)
■ If you are connecting to one or more computers with a hub, connect the computer to the
hub with one cable, and then connect the printer to the hub with the second cable. Connect
to any port on the hub except the uplink port.
See also:
Configuring the Network Address
Installing the Printer Drivers
on page 2-3
on page 2-4
on page 2-5
on page 2-9
Phaser® 8560 Color Printer
2-3
Choosing a Connection Method