Configuration Card Parameters - Xerox Phaser 8560 System Administrator Manual

Configuration Card
Parameters
The printer has a configuration card that stores network parameters and configuration (N, DN,
DX, etc.) data. The configuration card is hot swappable, enabling you to share or replace it,
providing an alternative to on-site service.
Network settings are saved on the configuration card. If the configuration card is removed
from an old printer and inserted into a new printer, the saved settings on the configuration card
are copied to the new printer when it is powered on. The new printer assumes the identity of
the old printer, eliminating the need to reconfigure network settings.
This appendix includes:
■ General Information Parameters
■ PostScript Parameters
■ PCL Parameters on page A-3
■ USB 2.0 Parameters
■ Hard Drive Parameters
Network Information Parameters
■
■ PhaserShare Series B Interface for Ethernet Network Parameters
■ EtherTalk Parameters
TCP/IP Parameters on page A-4
■
■ DNS Parameters on page A-5
■ SLP Parameters on page A-5
■ SSDP Parameter on page A-5
■ NBNS (WINS) Parameters
■ Access Control Parameter
■ LPR Parameters on page A-5
■ AppSocket (Port 9100) Parameters
■ IPP (Internet Printing Protocol) Parameters
■ SNMP Parameters on page A-6
CentreWare IS (HTTP) Parameters
■
■ FTP Parameters on page A-6
■ Status Notification Parameter
MaiLinX Remote Printing Parameters
■
on page A-2
on page A-2
on page A-3
on page A-3
on page A-3
on page A-4
on page A-5
on page A-5
on page A-6
on page A-6
on page A-6
on page A-7
on page A-7
System Administrator Guide
A-1
on page A-3