Table of Contents
Advertisement
Available languages
Available languages
Applications
Compressor/Limiter
The one application of the Solo Studio is to control the dynamic range of an audio signal. Plug a line level
(post preamplifier or other gain stage) source into the input, and set the threshold and output controls to
provide the desired amount of compression to the input signal.
Vocal and Instrument Leveling
The musical nature of the Solo Studio makes it ideal for use on a wide range of instruments and vocals.
Place the Solo Studio into a channel insert, after a preamplifier, or in line with the direct output of a mixer
channel. Adjust the controls of the Solo Studio to achieve the desired amount of compression.
ART maintains a policy of constant product improvement. ART reserves the right to make changes in design, or
make additions to, or improvements upon, this product without any obligation to install same on products
previously manufactured. Therefore, specifications are subject to change without notice.
6
Specifications - English
Specifications
Frequency Response 15 Hz to 50 kHz (+0, -1dB)
Dynamic range >110dB ("A" weighted)
CMRR >90dB
THD <0.005% (typical)
Equivalent Input Noise -129dBu (XLR, "A" weighted)
Maximum Input Level +19dBu (XLR)
Maximum Instrument Input +17dBu
Input Impedance 47k ohms (XLR),
Maximum Output Level +27dBu (XLR)
Output Impedance < 47 ohms (XLR)
Maximum Gain 55dB
Meter Calibration 0VU = +4dBu output (+4dBu mode)
Low Cut Filter single pole, 80Hz
Tilt EQ +/- 3dB adjustable
Power Requirements 100-240V 50Hz/60Hz
Dimensions: (HxWxD) 1.75-inch x 19-inch x 6.0-inch
Weight 5.6 lb / 2.5kg
>800k ohms (Instrument)
0VU = -10dBV output (-10dBV mode)
rear mounted switch and IEC connector
4.45 cm x 48.3 cm x 15.2 cm
Advertisement
Table of Contents
