Table of Contents
Advertisement
OPERATING THE DEHUMIDIFIER
1. If equipped, use the ON/OFF Power Switch, located by the
power cord, to apply power to the dehumidifier.
NOTE: The unit can remain plugged in with the ON/OFF Power
Switch on (if equipped) unless the unit will not be used for an
extended period. Use the ON/OFF Button on the user interface to
turn the unit off for short durations. When the unit is idle (neither
the fan nor the compressor running) the unit will use less than
3W of power�
FIGURE 1: EXTERIOR COMPONENTS OF THE DEHUMIDIFIER
A
A. USER INTERFACE
B. ON/OFF POWER SWITCH
(SELECT MODELS)
2. Use the ON/OFF Button (see FIGURE 2) on the user interface to
turn the dehumidifier ON. The first press of a button will turn
on the display light, so if the display was dark, you might
need to press it again. Once ON, the display will show the
current dehumidifier setting.
FIGURE 2: TURNING DEHUMIDIFIER ON
4
English
B
C
D
C. FILTER ACCESS DOOR
RETAINING SCREW
D. FILTER ACCESS DOOR
90-1854
90-1854
3. The dehumidifier blower will turn on, the word SETTING
disappears from the display, and the words AIR SAMPLING
appear (see FIGURE 3). This wording indicates that
the dehumidifier is sampling the air to determine if
dehumidification is needed and shows the measured
humidity level�
If the control is already ON, lowering the setting will initiate
air sampling�
FIGURE 3: AIR SAMPLING
4. After sampling the air for 3 minutes, if the Relative Humidity
(RH) is above the setting, the compressor turns on to
dehumidify the space� The word DEHUMIDIFYING appears
when the compressor is turned on (see FIGURE 4).
FIGURE 4: DEHUMIDIFYING
ENERGY SAVINGS TIPS
ENERGY SAVINGS TIP #1:
Adjust the humidity setting to be as high as is comfortable
to reduce dehumidifier run time. If it feels clammy or "smells
musty," lower the humidity setting� To save energy, turn the
dehumidifier to OFF when you open your windows, just as you
would with air conditioning�
ENERGY SAVINGS TIP #2:
If vacating your home for an extended period in the summer,
set the RH at 55% and set your thermostat as high as you are
comfortable setting it to in the cooling mode� This will keep the
humidity at a controlled level while minimizing the amount of
cooling energy used�
AIR SAMPLING
90-1854
90-1854
Advertisement
Table of Contents
Troubleshooting
