Advertisement
INSTALLATION
Selected Location
IMPORTANT: Due to the combined weight of the SaluSpa, water, and users, it is
extremely important that the surface where the SaluSpa is installed is smooth, flat,
level and capable of supporting the weight for the entire time the SaluSpa is installed
(not on the carpet or other similar material). If the SaluSpa is placed on a surface
which does not meet these requirements, any damage caused by improper support is
not covered under the manufacturer's warranty. It is the responsibility of the SaluSpa
owner to assure the integrity of the surface at all times.
1. Indoor Installation:
Be aware of special requirements if you install the spa indoors.
• Humidity is a natural side effect with SaluSpa installation. First determine the
effects of moisture on exposed wood, paper, etc. in the proposed location. To
minimize these effects, it is best to provide plenty of ventilation to the selected
area. An architect can help determine if more ventilation is needed.
2. Outdoor Installation:
• During filling, draining or when in use, water may spill out of the spa. Therefore
the SaluSpa should be installed near a floor drain.
• Do not leave the spa surface exposed to direct sunlight for long periods of time.
GFCI Test
IMPORTANT: RISK OF ELECTRIC SHOCK. THE GFCI MUST BE TESTED
BEFORE TURNING ON THE PUMP EACH TIME.
WARNING: The GFCI plug must be tested before each use to avoid risk of electric
shock.
WARNING: Before inserting plug into a power outlet, make sure the current rate of
the power outlet is suitable for the pump.
WARNING: Do not use the pump if this test fails and contact our Aftersales Service.
NOTE: When inflating, you will notice that air will be expelled from the area where the
air hose connects to the pump, this is normal
during in flation.
NOTE: Do not use an air compressor to
inflate.
NOTE: Do not drag on rough ground as this
may cause damage to the liner.
NOTE: Inflation time for reference only.
303021200339/90427E/14x21cm/客专SPA说明书
1. Plug the GFCI into a power outlet, the
indicator turns red.
2. Press the test button, the indicator turns off.
3. Press the reset button, the indicator turns red
and the spa is ready for use.
6
Advertisement
