Connect Wire Harness - Toro 30182 Operator's Manual

Connect Wire Harness

1. Route wire harness along inside of left handle
bracket (Fig. 6).
2. Plug clutch wire into connector (Fig. 6).
3. Secure wire harness and choke cable to upper
handle with cable tie (Fig. 6).
4. Route the other part of the wire harness around
to the right side of the engine.
2
Figure 6
1. Wire harness
2. Clutch wire connector
1
2 m–2795
3. Wire tie
5. Push the red regulator wires together (Fig. 7).
6. Secure the black ground wire, with the small
ring terminal, to the engine with #8 nut (Fig. 7).
7. Secure the other black ground wire, with large
ring terminal, to engine mount with 5/16 nut
(Fig. 7).
3
1. Regulator wire–red
2. Ground–small terminal
2
3 1
Figure 7
3. Ground–large terminal
Assembly
m–2403
13