Table of Contents
Advertisement
4. Carefully pull the hard disk assembly in the direction of arrow
5. Lift the hard disk assembly
-
6. Remove screws
and bracket
8
11
7. Reverse the process to install a new hard disk (do not forget to replace the screws).
c.
5
Installing 9.5mm or 7mm HDD
Note that the hard disks pictured on the following pages are all
7mm(h) hard disk drive.
In some cases 9.5mm(h) hard disk drives will be installed. It can be
installed on either upper or lower slot.
There are two hard disk drive options:
Two changeable 2.5" (6cm) 7.0mm (h) SATA (Serial) Hard Disk
Drives/Solid State Drives (SSD) supporting RAID level 0/1
Or
One changeable 2.5" (6cm) 9.5mm (h) SATA (Serial) Hard Disk
Drive/Solid State Drive (SSD)
For more information, contact your distributor/supplier, and bear in
mind your warranty terms.
out of the bay
(Figure 5d
).
6
7
from the hard disk
12
d.
).
(Figure 5c
5
)
(Figure 5e
.
13
6
7
e.
12
8
9
13
Disassembly
Figure 5
HDD Assembly
Removal (cont'd.)
c. Pull the HDD in the di-
rection of the arrow.
d. Lift the HDD assembly
out of the bay.
e. Remove the screws and
bracket from the HDD.
10
11
6. HDD Assembly
12. Adhesive Cover
13. HDD
• 4 Screws
Removing the Hard Disk Drive 2 - 9
Advertisement
Table of Contents
