Table of Contents
Advertisement
ASSEMBLY
SEAT
SEAT PAN
SHOULDER
BOLTS
FLAT WASHER
NN .....
ADJUSTMENT
KNOB
FIG. 2
CHECK BATTERY (See Fig. 3)
Lift seat pan to raised position.
If this battery is put into service after month and year
indicated on label (label located between terminals)
charge battery for minimum of one hour at 6-10 amps.
(See "BATTERY" in MAINTENANCE
section of this
manual for charging instructions).
SEAT
LABEL
NOTE: You may now roll or drive your tractor off the skid.
Follow the appropriate instruction below to remove the
tractor from the skid.
TO ROLL TRACTOR
OFF SKID
(See Op-
eration
section
for location
and function
of
controls)
Press lift lever plunger and raise attachment lift lever
to its highest position.
Release parking brake by depressing clutch/brake
pedal.
Place freewheel control in "transmission disengaged
position" (See "TO TRANSPORT" in the Operation
section of this manual).
Roll tractor forward off skid.
Remove banding holding the deflector shield up against
tractor.
TO DRIVE
TRACTOR
OFF SKID (See
Op-
eration
section
for location
and function
of
controls)
_IbWARNING: Before starting, read, understand and follow
all instructions in the Operation section of this manual. Be
sure tractor is in a well-ventilated area. Be sure the area in
front of tractor is clear of other people and objects.
Be sure all the above assembly steps have been com-
pleted.
Check engine oil level and fill fuel tank with gasoline.
Place freewheel control in "transmission engaged"
position (see "TO TRANSPORT" in Operation section
of this manual).
Sit on seat in operating position, depress clutch/brake
pedal and set the parking brake.
Place motion control lever in neutral (N) position.
Press lift lever plunger and raise attachment lift lever
to its highest position.
Start the engine. After engine has started, move throttle
control to idle position.
Release parking brake.
Slowly move the motion control lever forward and slowly
drive tractor off skid.
Apply brake to stop tractor, set parking brake and place
motion control lever in neutral position.
Turn ignition key to "STOP" position.
Continue with the instructions that follow.
FIG. 3
Advertisement
Table of Contents
