Table of Contents
Advertisement
SERVICE
AND ADJUSTMENTS
SIDE-TO-SIDE ADJUSTMENT (See Figs. 16 and 17)
Raise mower to its highest position.
At the midpoint of both sides of mower, measure height
from bottom edge of mower to ground.
Distance "A"
on both sides of mower should be the same or within
1/4" of each other.
If adjustment is necessary, make adjustment on one
side of mower only.
To raise one side of mower, tighten lift link adjustment
nut on that side.
To lower one side of mower, loosen lift link adjustment
nut on that side.
NOTE: Three full turns ofadjustment nutwill change mower
height about 1/8".
Recheck measurements after adjusting.
BOTTOM EDGE OF
BOTTOM EDGE
MOWER
F
q
--qOFMOWER
7 GROUNDL=E
FIG. 16
_\
SUSPENSION ARM
c--',3
/
LIFT LINKADJUS_
"
FIG. 17
FRONT-TO-BACK
ADJUSTMENT
(See Figs.
18 and
19)
IMPORTANT:
DECK MUST BE LEVEL
SIDE-TO-SIDE.
IF THE
FOLLOWING
FRONT-TO-BACKADJ
USTMENT
IS NECESSARY,
BE SURE
TO ADJUST
BOTH
FRONT
LINKS
EQUALLY
SO
MOWER
WILL STAY LEVEL SIDE-TO-SIDE
To obtain the best cutting results, the mower housing
should be adjusted so that the front is approximately 1/8"
to 1/2" lower than the rear when the mower is in its high-
est position.
Check adjustment on right side of tractor. Measure distance
"D" directly in front and behind the mandrel at bottom edge
of mower housing as shown.
Before making any necessary adjustments, check that
both front links are equal in length.
If links are not equal in length, adjust one link to same
length as other link.
To lower front of mower loosen nut "E" on both front
links an equal number of turns.
When distance "D" is 1/8" to 1/2" lower at front than rear,
tighten nuts "F" against trunnion on both front links.
To raise front of mower, loosen nut "F" from trunnion
on both front links. Tighten nut "E" on both front links
an equal number of turns. The two front links must
remain equal in length.
When distance "D"is 1/8" to 1/2" lower at front than rear,
tighten nut "F" against trunnion on both front links.
Recheck side-to-side adjustment.
FIG. 18
BOTH FRONT LINKS MUST BE EQUAL IN LENGTH
NUT "F'
TRUNNION
NUT "E"
FRONT LINKS
FIG. 19
TO REPLACE
MOWER
BLADE DRIVE BELT
(See Fig. 20)
The mower blade drive belt may be replaced without tools.
Park the tractor on level surface. Engage parking brake.
BELT REMOVAL -
Remove mower from tractor
(See "TO REMOVE
MOWER" in this section of this manual).
Work belt off both mandrel pulleys and idler pulleys.
Pull belt away from mower.
BELT INSTALLATION -
Install new belt in reverse order of removal.
Make sure belt is in all pulley grooves and inside all
belt guides.
Install mower in reverse order of removal instruc-
tions.
MANDREL
IDLER
PULLEYS
MANDREL
PULLEY
20
FIG. 20
Advertisement
Table of Contents
