Xerox Phaser 8510MFP Advanced Features Manual page 74

Changing the Load Paper Timeout
When your print job is formatted for a type or size of paper that is not loaded in the system, the
system's control panel displays a message requesting you to load the appropriate paper. The
Load Paper Timeout value controls the amount of time the system waits before printing on
another type or size of paper.
To change the Load Paper Timeout value, use one of the following options:
■ The system's control panel
■ CentreWare IS
Using the Control Panel
To change the Load Paper Timeout value on the control panel:
1. Press the System button.
2. Select
General Setup
3. Select
Paper Handling Setup
4. Select
Load Paper Timeout
5. Scroll to the desired timeout value. The values (
hours) indicate the length of time you want the system to wait for you to load paper
24
before printing. If you select a value of
inserted and immediately picks paper from the default tray.
6. Press the OK button to save the change.
Using CentreWare IS
To change the Load Paper Timeout value using CentreWare IS:
1. Launch your web browser.
2. Enter your system's IP address in the browser's Address field (http://xxx.xxx.xxx.xxx).
3. Click Properties.
4. Select the General folder on the left sidebar, and then select System Defaults.
5. Scroll to the desired Load Paper Timeout value in Timeout Settings. The values (None,
1, 3, 5, or 10 minutes, 1 or 24 hours) indicate the length of time you want the system to
wait for you to load paper before printing. If you select a value of None, the system does
not wait for paper to be inserted and immediately picks paper from the default tray.
6.
Click the Save Changes button at the bottom of the screen.
Phaser® 8510/8560MFP Multifunction Product
, and then press the OK button.
, and then press the OK button.
, and then press the OK button.
, the system does not wait for paper to be
None
4-13
, , , , or minutes,
None 1 3 5 10
System Settings
hour or
1