I/O Specifications - Omron F160-2 Setup Manual

Connecting through the Parallel Interface
B8
B9
B10
B11
B12
B13
B14
B15
B16
B17
B18
B19
B20
Note
1.
SeeAlso
2.
Precaution
Do not input the RESET input immediately after turning ON the power. When
using RESET input to synchronize startup timing, wait at least 1 s after turning
ON the F160's power supply before turning ON the RESET signal.
CHECK
Use a DC power supply with countermeasures against high voltages (safe
extra low-voltage circuits on the secondary side) for the COMIN terminal. If the
system must meet UL standards, use a UL class II power supply.
Making a Parallel I/O Cable
A parallel I/O cable can be assembled using the connector and cover listed in
the following table or equivalent components. Keep the cable length less than
30 m.
Connector
Cover
CHECK
Double-check the connector wiring for mistakes before turning ON the power
supply for the first time.
4-1-3

I/O Specifications

Input Specifications
Item
Model
Input voltage
ON current (See note 1.)
ON voltage (See note 1.)
OFF current(See note 2.)
OFF voltage(See note 2.)
ON delay
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Pin Signal Wire color
STGOUT1 Green
ERROR Gray
GATE White
Light brown ■■■ (red)
COMOUT1
DO1 Yellow
DO3 Green
DO5 Gray
DO7 White
Light brown ■■■■ (red)
COMOUT2
DO10 Yellow
DO12 Green
DO14 Gray
COMOUT3 White
Use the STGOUT0 or STGOUT1 signal when you want to connect a strobe
device to the F160.
For details, refer to page 61.
Pins A8 to A11 and B9 to B10 are for control signals.
Component
Fujitsu
Fujitsu
F160-C10E (NPN mode)
12 to 24 VDC ± 10%
5 to 15 mA
8.8 V max.
0.1 mA max.
4.5 V min.
RESET input: 10 ms max.
Other inputs: 0.5 ms max.
Marking
■■ (red)
Strobe trigger 1 output
(See note 1.)
■■ (red)
ON when an error occurred.
■■ (red)
ON for the set output time.
Common for control signals
(See note 2.)
■■■ (red)
Data output
■■■ (red)
■■■ (red)
■■■ (red)
Common for DO0 to DO7
■■■■ (red)
Data output
■■■■ (red)
■■■■ (red)
■■■■ (red)
Common for DO8 to DO15
Manufacturer
Specification
F160-C15E (PNP mode)
Section 4-1
Function
Model number
FCN-361J040-AU
FCN-360C040-B
33