Weld Process Board Pc4 Diagnostic Leds; Diagnostic Leds On Process Board Pc4 - Miller Axcess 300 Owner's Manual

9-2. Weld Process Board PC4 Diagnostic LEDs

1

9-3. Diagnostic LEDs On Process Board PC4

LED Status
1 On
Off
2 On
Off
3,4 On
Off
OM-216 967 Page 34
Indicates −25 volts DC is present on process board PC4
Indicates −25 volts DC is not present on process board PC4
Indicates +25 volts DC is present on process board PC4
Indicates +25 volts DC is not present on process board PC4
See Network Status Table in Section 9-4
See Network Status Table in Section 9-4
1 Weld Process Board PC4
Diagnostic LEDs are visible inside unit,
located on PC4 mounted on the top tray.
Refer to Section 9-3 for information on
diagnostic LEDs.
Reinstall cover after checking diagnostic
LEDs.
LED1
LED2
LED3
LED4
Diagnosis
216 956-A / Ref. 803 670-A