Uniden MHS338BT Owner's Manual page 24

Soft Key
CALL
TXP
TRI
MEM
MEMSCN
ALLSCN
E-20
Description
The CALL soft key opens a CALL menu. You can use this menu
as a "shortcut" to make different kinds of calls, access DSC logs,
and set Auto Polling.
NOTE: Some call types use the information previously set
up in the menus to configure the call parameters.
For example, if you select INDIVIDUAL CALL through
the CALL soft key, a list of ships that were set up
through MENU/DSC SETUP/INDIVIDUAL DIRECTORY
displays.
You can also manually enter the other party's location.
Transmit Power. This soft key changes the transmit power from
6.0W to 2.5W to 1.0 Watts. The transmit power level displays on
the LCD screen.
NOTE: If you try to change transmission power output but
the channel is limited to 1.0W or less by regulation,
the radio sounds an error tone and stays at 1.0W.
Triple/Dual Watch. This soft key activates or deactivates Dual or
Triple watch mode that was assigned through the menus. See
page E-30 to assign the watch mode through the menu and to
activate the mode through the soft keys.
Dual Watch monitors the current channel and CH16.
Triple Watch monitors the current channel, CH16, and the
Priority channel.
NOTE: The soft key only turns the currently set mode on
or off; it does not switch between TRI and DUAL
modes.
Memory. Press this soft key to save the current channel into
memory. The M icon displays.
Press it again to remove the current channel from memory; the
M icon does not display.
Memory Scan. Select the MEMSCN soft key to start or stop
scanning channels saved into memory.
MEMSCN displays on the LCD.
All Scan. Select the ALLSCN soft key to start or stop scanning
all channels. A-SCAN displays on the LCD.
MHS338BT Radio Owner's Manual