Cisco Nexus 93108TC-FX3 Hardware Installation Manual page 29

Installing the Switch Chassis
b) Gently slide the switch all the way into the rack until the front rack-mount brackets come in contact with the cabinet
posts.
Note
c) Holding the chassis level, insert screws (12-24 or 10-32, depending on the rack type) in each of the two front rack-mount
brackets (using a total of six screws) and into the cage nuts or threaded holes in the vertical rack-mounting rails (see
the following figure).
d) Tighten the 10-32 screws to 20 in-lb (2.26 N·m) or tighten the 12-24 screws to 30 in-lb (3.39 N·m).
Step 4 If you attached a grounding wire to the chassis grounding pad, connect the other end of the wire to the facility ground.
Installing the Switch into a Two-Post Rack Using the NXK-ACC-KIT-1RU Rack-Mount Kit
If you attached a grounding cable to the chassis, you will need to bend one of the rack-mounts slightly
to allow the grounding lug to go behind the rail.
Cisco Nexus 93108TC-FX3 ACI-Mode Switch Hardware Installation Guide
23