X10 UX21A Owner's Manual page 4

Basic Setup
Press REC on the VCR Commander and release it. The red light
blinks quickly and then stays on. Press the Record button on your
remote and keep pressing until the red light on the VCR
Commander briefly goes out and comes back on solid. This means
that Record has been learned.
Press STOP on the VCR Commander and release it. The red light
will blink quickly and then stay on. Press the Stop button on your
remote and hold it down until the red light on the VCR Commander
briefly goes out and comes back on. This means that Stop has
been learned.
6 6 6 6 6
Plug the IR emitter cable into the back of the VCR Commander.
Remove the plastic from the adhesive backing from one of the
infrared emitters and press it onto the VCR you are going to
control. Attach the emitter cable near the spot on the VCR where
you usually point your VCR remote control. See page 11 for more
help with this.
7 7 7 7 7
Basic Setup