Basic Setup
Press and hold PLAY until the red light stays on.
Press the HOUSE button on the motion sensor. The red light on
the VCR Commander will go out. This motion sensor will now
start your VCR Commander. Point the motion sensor away from
where you are working and away from motion so that you can set
up the rest of the system.
4 4 4 4 4
Position your VCR remote control about one inch away from the
back of your VCR Commander, pointing at the infrared (IR)
receptor.
Press and hold REC until the red light stays on. The VCR
Commander is now in Learn Mode.
5 5 5 5 5
Basic Setup
Infrared (IR)
Receptor