Advertisement
"PEDAL (COVER)
. THUMB SCREW
SPRING BASE
i
COIL SPRING
PEDAL
GUIDE
SOUR
BATTERY
**.
BATTERY
CONNECTOR
STRAP
REPLACING BATTERY
USE ONE 9-VOLT BATTERY.
@Loosen the screw of pedal to open it
and take out battery from its housing.
@Replace the battery by a fresh one and
put it into position.
Set coil spring onto the projection on
the rear of the pedal and shut the
cover (pedal). Finally, insert the screw
into the pedal guide and tighten it.
At this time, be careful not to catch
the battery strap in the cover or coil
spring.
CAUTIONS
elf battery voltage drops, effect becomes
inferior or no sound is produced. To
prevent that, replace the battery a little
earlier.
AC ADAPTOR (OPTION)
BOSS ACA.240
FOR 240V AC
BOSS ACA-120
FOR 117V AC
*Be sure to keep the battery snapped by
connector into the housing, when using
AC adaptor, too.
"Even if AC Adaptor cord comes out
during performance, operations imme-
diately changes to battery, causing no
trouble in continued performance.
Power is switched on while a plug is put
into input jack. When you do not use,
keep the plug off the jack.
Use BOSS AC adaptor
for AC operation.
Use of different
adaptors may cause
improper operation
orno sound.
BOSS ACA:220
FOR 220V AC
Advertisement
