Scan To Ftp - Pantum PT16B2B Series User Manual

11. If you want to perform a merge scan, place the documents that you want to continue scanning
on the glass platen, press the "Start" button and proceed with scanning the second page. (ADFsd
can make scan continuously without interruption.)
Instructions for settings of group e-mail sending:
Set the group name for group e-mail sending by webpage, and set the members, i.e.the receivers,
in the group of group email. After finishing scanning, firmware will send the scanned documents to
the mail server. Then mail server sends the documents to every member of the group.

Scan to FTP

Be sure the user is in an Internet-connected environment in scanning files to FTP server. If you
want to scan large files, you may need to input the server address, user name and password to log
in the server, with specific operation steps as below:
1. Be sure the printer and the computer are both switched on and connected with each other
properly.
2. Configure the FTP address book.
3. Put an original on the glass platen or into the ADF
4. Press "Scan" button on the control panel, and press "▲" or "▼" to select "Single Page Scan" or
"Merge Scan", then press "OK" button.
5. Press "▲" or "▼" to select "E-mail Address Book" or "Group Mail" and press "OK" button.
6. Press "▲" or "▼" to select the options under "Scan to", and then press "OK".
7. Press "▲" or "▼" to select "Scan to FTP", and then press "OK".
8. Press "▲" or "▼" to select the server. Press "OK". Press "Start" to start the scan.
9. If you want to perform a merge scan, place the documents that you want to continue scanning
on the glass platen, press the "Start" button and proceed with scanning the second page. (ADFsd
can make scan continuously without interruption.)
27