Fcc Caution - X10 VR30A Owner's Manual

I
NTRODUCTION
The VR30A Video Receiver works with X10's Wireless Video Sender kit
(VK30A) for situations where you want to install an additional receiver on
another TV, for example. The VK30A's Sender base unit connects to your
DBS™ receiver, VCR, Cable Box, etc., and the Receiver unit connects to a
TV in another room. The Video Sender converts the A/V signal from your
DBS receiver, VCR, Cable Box, etc., into a radio signal and transmits it
(even through walls) to the Video Receiver unit. The Video Receiver
converts the signals back to A/V signals which are fed through a cable to
your TV's COAX or A/V input jacks. By purchasing additional VR30As
you can view your DBS receiver VCR, Cable Box, etc., on more than one
TV.
FCC C
AUTION
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES.
OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS:
(1)THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND
(2)THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING
INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.
This equipment generates and uses radio frequency energy, and if not installed and used
properly, that is, in strict accordance with the manufacturers instructions, it may cause
interference to radio and television reception. It has been type tested and found to comply
with the limits for remote control devices in accordance with the specifications in Sub-Parts
B and C of Part 15 of FCC Rules, which are designed to provide reasonable protection
against such interference in a residential installation. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
interference to radio or television reception, which can be determined by unplugging the
equipment, try to correct the interference by one or more of the following measures.
• Reorient the antenna of the radio/TV experiencing the interference.
• Relocate the equipment with respect to the radio/TV.
• Move the equipment away from the radio/TV.
• Plug the equipment into an outlet on a different electrical circuit from the radio/TV
experiencing the interference.
• If necessary, consult your local Dealer for additional suggestions.
NOTE: Modifications to this product will void the user's authority to operate this
equipment.
2 2 2 2 2
C C
ONTROLS AND ONNECTIONS
TV Output
Connector
Power Supply
A/V Jacks
TV
Channel
Switch
2.4 GHz
Channel
Switch
3 3 3 3 3
2.4 GHz Video
Antenna
ON-OFF
Switch
(on side)
Jack