Table of Contents
Advertisement
'A' fault codes
Follow the steps below to try and fix the issue.
PROBLEM
POSSIBLE CAUSE
A20
Drain hose is crimped
or bent.
Drain fault
Blocked
drain connection.
The waste water is not
draining out.
The turbidity
sensor is dirty and
requires cleaning.
Drain pump is blocked.
A10
Water tap not
turned on.
No water
Insufficient water
supply pressure.
Water inlet hose is
crimped or bent, so no
or not enough water
gets to the dishwasher.
Drain hose is not
connected correctly.
36
FAULT CODES
WHAT TO DO
Check the drain hose and straighten if needed.
Check that drain connection is free from blockages.
Ensure that the drain hose is connected in accordance with the
installation instructions.
Gently clean the turbidity sensor with a soft brush
(ie toothbrush) to remove any buildup.
Turbidity
sensor
Remove the drain filter and clear any water from the drain.
Remove the sump insert and pump cover.
Remove any remnants of food or blockages from the pump.
Take care in case sharp objects or fragments of glass are
blocking it, as these may cause injury.
Pump
cover
Ensure the water is connected and turned on.
Touch
to restart the dishwasher.
Check household water pressure.
Check the water inlet hose and straighten if needed.
Touch
to restart the dishwasher.
Ensure that the drain hose is connected in accordance with the
installation instructions.
Sump
insert
Advertisement
Table of Contents
