Fisher & Paykel DW60FC4W1 Manual

Fault codes

If the dishwasher malfunctions, it will display a fault code and beep. Check the table below to see if you can correct the
fault yourself before contacting Fisher & Paykel Customer Care.
If the dishwasher still will not work, or shows any other fault code
1. Press
to turn the dishwasher off and wait a few minutes.
2. Press
again to turn the dishwasher back on.
If the dishwasher still does not function and/or the problem persists, disconnect the dishwasher from the power
supply, turn the water supply off, then contact Fisher & Paykel Customer Care with the fault code information.
Fault codes
and
Descriptions
Drain hose is crimped or bent.
The waste water is not draining
out.
Drain fault
The turbidity sensor is dirty and
requires cleaning.
Possible Causes
https://producthelp.fisherpaykel.com/au/Clean/Dishwashers/DW60FC4W1/User_Guide_DW60FC4W1/15_Fault_codes
Check the drain hose and straighten if needed.
Ensure that the drain hose is connected in accordance with
the installation instructions.
Gently clean the turbidity sensor with a soft brush (ie
toothbrush) to remove any buildup.
What to do
Updated: Sat, 15 Feb 2020 09:20:35 GMT
Powered by
1