Daily Use - Drying Only - Electrolux EW9W1165RC User Manual

To have a good drying by using less
energy and in a shorter time, the
appliance does not let you set a too low
spin speed for the items to be washed
and dried.
2. Touch button Départ/Pause to start the
programme. The SensiCare estimation
starts.
In the display the door locked
goes on, the indicator of the running phase
starts flashing.
The display also shows the remaining
programme time.
13.3 Washing and Timed Drying
1. Tap on the button Minuterie repeatedly to
set the desired time value (see the
"Timed drying" table the "Programmes"
chapter). The drying level indicator goes
off and the indicator
The minimum timed drying is 10 minutes.
Each time you tap on this button the time
value increases by 5 minutes. The display
shows the set new time value.
2. Touch the Départ/Pause to start the
programme. The SensiCare estimation
starts.
In the display the door locked
comes on and the indicator of the running
phase starts flashing.

14. DAILY USE - DRYING ONLY

WARNING!
Refer to Safety chapters.
This appliance is an automatic washer
dryer.
14.1 Preparation to drying
1. Press the Marche/Arrêt button for some
seconds to activate the appliance.
indicator
comes on.
indicator
The display also shows the remaining
programme time.
13.4 At the end of the drying
programme
• The appliance stops automatically.
• The acoustic signals operate (if they are
active).
• In the display comes on.
• The indicator of button Départ/Pause goes
off. The door locked
• Press the button Marche/Arrêt for some
seconds to deactivate the appliance.
After some minutes from the end of
the programme, the energy saving
function deactivates the appliance
automatically.
1. Remove the laundry from the appliance.
2. Make sure that the drum is empty.
After drying phase, clean the drum, the
seal and the inside of the door with a wet
cloth.
The indicator appears on the display
to remind you to clean the air filter (refer
to 'Cleaning the air filters' in 'Care and
cleaning' chapter).
With a drying-only programme the
display does not show the maximum load
and the SensiCare estimation is
deactivated.
2. Load the laundry one item at a time.
3. Turn the programme dial to the
programme suitable for the items to dry.
4. Tap on the Mode button twice to exclude
washing and perform drying only. The
Séchage indicator is on. The indicators
and
goes off
appear on the display.
ENGLISH 33