Daily Use - Drying Only - Electrolux EW8WB864T3 User Manual

The time value on the display is the
duration of both cycles washing and
drying, calculated on a default load size.
To have a good drying by using less
energy and in a shorter time, the
appliance does not let you set a too low
spin speed for the items to be washed
and dried.
2. Touch button Start / Pause
the programme. The SensiCare
estimation starts.
In the display the door locked
comes on.
The display also shows the remaining
programme time.
13.3 Washing and Timed Drying
1. Tap on the Time Dry button repeatedly to
set the desired time value (see the
"Timed drying" table in the "Programmes"
chapter). The drying level indicator
goes off and the indicator
Each time you tap on this button the time
value increases by 5 minutes. The display
shows the set new time value.
2. Touch the Start / Pause
start the programme. The SensiCare
estimation starts.
In the display the door locked
comes on.
The display also shows the remaining
programme time.

14. DAILY USE - DRYING ONLY

WARNING!
Refer to Safety chapters.
This appliance is an automatic washer
dryer.
14.1 Preparation to drying
1. Press the On/Off button for some
seconds to activate the appliance.
13.4 At the end of the drying
programme
• The appliance stops automatically.
• The acoustic signals operate (if they are
• In the display
• The indicator of the Start / Pause button
to start
indicator
• Press the On/Off button for some seconds
comes on.
After some minutes from the end of
the programme, the energy saving
function deactivates the appliance
automatically.
button to
1. Remove the laundry from the appliance.
2. Make sure that the drum is empty.
indicator
After drying phase, clean the drum, the
seal and the inside of the door with a wet
cloth.
2. Load the laundry one item at a time.
3. Turn the programme dial to the
4. Tap on the Dry Mode button twice to
active).
goes off. The door locked
off.
The appliance continues to operate with
the anti-crease phase for approximately
30 minutes or more if Anti-crease option
was set.
The anti-crease phase reduces creasing.
You can remove the laundry before the
anti-crease phase is completed. We
recommend, for better results, that you
remove the laundry when the phase is
almost completed or completed. The
indicator remains lit.
to deactivate the appliance.
programme suitable for the items to dry.
The appliance defaults to the washing
only mode and the indicator of the Wash
Mode button is on.
perform drying only. The indicator of Dry
Mode button illuminates and the indicator
of Wash Mode button goes off. The
comes on.
goes
ENGLISH 43