Table of Contents
Advertisement
Quick Guide
2. Quick Guide
This chapter is to introduce the preparation of the UT8806E digital multimeter and simply introduce the
front/rear panel and display screen.
2.1 General Inspection
Before you use a new UT8806E multimeter, it is recommended that you check the instrument as follows.
(1)
Check for damage caused by transportation
If you find that the packing carton or protective foam cushion is badly damaged, keep it until the
complete unit and accessories have passed the electrical and mechanical tests.
(2) Checking accessories
If you find that an accessory is missing or damaged, contact the UNI-T distributor responsible for your
business or the local UNI-T office.
(3) Checking the complete unit
If you find that the instrument is visually damaged, that the instrument is not working properly, or that it
fails a performance test, contact the UNI-T distributor responsible for the operation or the local UNI-T
office.
If the instrument is damaged due to transportation, please retain the packaging. Notify the shipping
department and the UNI-T distributor. UNI-T will arrange for repair or replacement.
2.2 Before Use
To perform a quick verification of the instrument's normal operations, please follow the steps below.
(1) Connect to the Power Supply
The power supply voltage range is from 100 VAC to 240 VAC, the frequency range is 45 Hz to 440 Hz. Connect
the multimeter to the power supply line that equipped with the product or any power supply line that meets
the local country standards. When the multimeter is connected to the invalid power supply, the indicator of
the power soft switch button
button has no effect at this time; when the multimeter is correctly connected to the valid power supply, the
indicator of the power soft switch button at the lower left corner of the front panel of the multimeter will be
red, and the multimeter can be turned on by pressing the soft switch button at this time.
(2) Boot Check
Press the soft power button
the screen. The multimeter will show a boot animation, and then enter the normal interface.
Warning: To avoid electric shock when using the probe to measure high voltage, please ensure that the probe
insulation is in good condition and avoid physical contact with any metallic part of the probe.
Instruments.uni-trend.com
at the lower left corner of the front panel will not be lit, and the soft switch
and the light should change from red to green, and UNI-T will display on
UT8806E Desktop Digital Multimeter
5 / 13
Advertisement
Table of Contents
