Immobilizer Related Part; Service Parts - Subaru BRZ 2016 Service Manual

NOTE

8. IMMOBILIZER RELATED PART

• Do not replace the immobilizer related parts with the parts from other vehicle.
• Registration of the immobilizer is necessary when a immobilizer-related control module has been re-
placed. For detailed operation procedure, refer to the "REGISTRATION MANUAL FOR IMMOBILIZER" pro-
vided as a separate volume.

9. SERVICE PARTS

Use genuine parts for maximum performance and maintenance when conducting repairs. Subaru/FHI will
not be responsible for poor performance resulting from the use of parts except for genuine parts.
10.PROTECTING VEHICLE UNDER MAINTENANCE
Make sure to attach the fender cover, seat covers, etc. before work.
11.ENSURING SECURITY DURING WORK
When working in a group of two or more, perform the work with calling each other to ensure mutual safety.
12.LIFT AND JACK
When using a lift or shop jack to raise a vehicle or using rigid rack to support a vehicle, always follow instruc-
tions concerning jack-up points and weight limits to prevent the vehicle from falling, which could result in in-
jury. Be especially careful that the vehicle is balanced before raising it. Be sure to set the wheel stoppers
when jacking-up only the front or rear side of the vehicle.
CAUTION:
Select the lift attachment so that the side sill does not contact the lift arm.
NOTE:
• When using a lift, follow its operation manual.
• When the side sill cover contacts the lift arm, use a lift attachment.
• Do not work or leave unattended while the vehicle is supported with jack, support it with rigid racks.
• Be sure to use the rigid racks with rubber attached to cradle to support the vehicle.
• When using a lift, use an attachment or something similar.
• When using a plate lift, use a rubber attachment. Place the attachment to the specified position of the ve-
hicle, by adjusting front/rear and left/right sides accordingly.
(A)
(B)
(A) 80 mm (3.1 in) or more
(B) 80 — 100 mm (3.15 — 3.94 in)
(C) 120 — 200 mm (4.72 — 7.87 in)
• Align the cushion rubber center part of plate lift with the center part of rubber attachment.
• Do not use the plate lift whose attachment does not reach the supporting locations.
Note
(C)
NT-00070
NT-6