Removed Part; When Removing Battery; Adjustment Service Procedures Performed Before Delivery To Custom- Er - Subaru BRZ 2016 Service Manual

5. REMOVED PART

• A removed part must be organized to avoid mixing up with similar parts. When same parts are used in mul-
tiple locations, such as pistons in engine, manage the parts by using labels with cylinder No. so that the parts
are not installed to the wrong location.
• Always replace nonreusable parts such as gasket and O-ring with new parts.
• After work, have a customer confirm the replaced part.

6. WHEN REMOVING BATTERY

• To prevent damaging the retainer & molding assembly, completely close the front door glass on driver's
and passenger's sides before removing the battery.
• When removing battery, power supply is cut off and the information stored in the computer memory is vol-
atilized. Therefore, setting information of some device is initialized to the factory default. The device and
functions initialized by removing battery are as follows.
No.
1 Clock
Temperature setting of fully automatic air
2
conditioner (Setting made by customer)
3 Power window system
4 Steering lock system
5 Electronic throttle system
6 Engine control system
7 Past trouble history (memory code)
7. ADJUSTMENT SERVICE PROCEDURES PERFORMED BEFORE DELIVERY TO CUSTOM-
ER
Perform the following procedures before delivering the vehicle to the customer according to maintenance
performed and parts replaced.
No. Item
Each device location
• Steering
• Room mirror
1
• Door mirror
• Seat
• Air conditioning vent grille
Position of all switches
• Wipers, lights (AUTO or
OFF)
2 • Illumination control
• Room light
• Seat heater and similar
parts
3 Antenna position
Item
Set to the clock to the current time.
Restore to the setting before removing battery.
Perform initialization of automatic full open/close of driver's window (power
window system).
If the engine does not start, initialize the steering lock system.
Turn the ignition switch to ON, and wait 10 seconds before starting the
engine.
With no electronic loads applied, allow the engine to idle until it is com-
pletely warmed up (until the radiator fan is activated two times or more).
Check points
Are all devices in the
same positions as when
the vehicle was received
from the customer?
Are all switches in the
same positions as when
the vehicle was received
from the customer?
Is the antenna in the same
positions as when the
vehicle was received from
the customer?
Note
Procedures for connecting the battery
Adjustment procedures
Adjust all devices to be in
the same positions as
when the vehicle was
received from the cus-
tomer.
Return all switches to the
same positions as when
the vehicle was received
from the customer.
Adjust antenna position.
NT-3
—
Adjustment procedures also per-
formed when replacing parts
During device removal/installation
procedures
• Motor, instrument panel, steer-
ing column and similar parts
• Room mirror, roof trim and sim-
ilar parts
• Door mirrors, door panels and
similar parts
• Seats, floor carpet, parking
brake lever and similar parts
• Vent grilles, instrument panel,
console box and similar parts
During switch removal/installa-
tion procedures
During antenna removal/installa-
tion procedures and car wash
NOTE