Super Clean System - Viking DESIGNER Series Manual

1) Set Temperature
2) Turn to On
3) Drain Pump will be on for 30 sec.
4) Fill Valve will open for 60 sec.
Supplying 1.3 gallons of water.
5) Prewash for 5 or 6 min (Not Heated)
6) Drain Pump turns on and drains water
to just over the top of the filter (1/8")
7) Then the Circulating Pump turns on the
45 to 50 sec. to wash the bottom of the
tank and filter.
8) Actions stops for 1 minute.
9) The Drain Pump turns on and drains unit
10) The Fill Valve turns on and regular wash
begins.
11) After water reaches the set temperature
the unit will wash for 20 minutes.
Super clean system: Normal cycle
609
12) Stops
13) Drain Pumps for 30 seconds.
14) Fill Valve on for 60 seconds (1 minute)
15) Rinses for 4 minutes.
16) Drains.
17) Refills for 2nd rinse (5 minute rinse
cycle after reaching set temperature.)
18) Drains
19) Heating Element on for drying cycle.
(The heating element will cycle on and
off depending on the temperature setting
during the drying cycle.)
20) Vent opens after 30 seconds into the
drying cycle.
21) Drying cycle is approximately 12
minutes.
Plugged fine
horizontal filter which is located in the
center of fine filter. Remove the
filter and clean the underside. Replace
fine filter and screw horizontal filter
back in place.
Lift out the coarse strainer and empty
the large objects that cannot pass
through the drain pump.
filter: Unscrew