Table of Contents
Advertisement
Fault
The programme dura-
tion changes during
the wash cycle.
No water is visible in
the drum.
Drum jerks after the
programme starts.
Vibrations and move-
ment of the appliance
whilst spinning.
Heavy foam build-up
i-DOS
i-DOS
cannot be actuated.
High spin speed not
reached.
Cause and troubleshooting
Note: When loading, where possible, place large and
small items of laundry together in the drum. Different
sized items of laundry distribute themselves better
during the spin cycle.
Foam detection system switches on a rinse cycle if
foam build-up is too high.
Not a fault – no action required.
▶
Water is below the visible area.
Not a fault – no action required.
▶
Do not add any extra water to the appliance while it
▶
is operating.
This is caused by an internal motor test.
Not a fault – no action required.
▶
Appliance is not correctly aligned.
→ "Aligning the appliance", Page 15
▶
The appliance feet are not fixed.
Secure the appliance feet.
▶
→ "Aligning the appliance", Page 15
Transit bolts have not been removed.
→ "Removing the transit bolts", Page 13.
▶
Detergent dosage is too high.
Immediate measure: Mix one tablespoon of fabric
▶
softener with 0.5 litres of water and pour the mix-
ture into the compartment for manual dosing (not
for outdoor clothing, sportswear or items stuffed
with down).
If intelligent dosing is activated, reduce the basic
▶
dosage → Page 35.
If you dose manually, reduce the amount of deter-
▶
gent for the next washing cycle with the same load.
Intelligent dosing is not intended for this programme.
Not a fault – no action required.
▶
→ "Starting the programme with intelligent dosing
system", Page 33
Programme progress does not allow intelligent dos-
ing.
No remedial action possible.
A low spin speed is selected.
The next time you run a wash cycle, set a higher
▶
spin speed.
Troubleshooting en
51
Advertisement
Table of Contents
