Wolf CT15G/S Use & Care Information Manual page 16

W O L F
C O O K TO P
Wait until surfaces are cool before cleaning.
For best results, wipe up spills and spatters
as they occur and immediately after the
cooktop has cooled. If splatters are allowed
to cook on, they may permanently damage
S I G N AT U R E
or stain the finish.
P O L I S H
If in doubt about using one of your
cleaners, check the label. To check if it is
Signature Polish
safe to use on your cooktop, try a small
is available from
amount on an inconspicuous area using
Signature Limited
very light pressure.
Laboratory,
P. O. Box 13436,
Use caution when spraying cleaners. Some
Dayton, Ohio
contain caustic ingredients that can damage
45413-0436, or
adjacent parts and finishes. Protect the
call 877-376-5474
adjacent parts by masking them off so that
(toll free).
the overspray is contained to the finish
being cleaned.
Do not spray cleaners on electrical controls,
igniters, wires or knob valve stems.
16
G A S C O O K TO P U S E & C A R E
C L E A N I N G T I P S
S T A I N L E S S S T E E L F I N I S H
For the classic or platinum stainless steel
exterior finish, use a soft, nonabrasive
stainless steel cleaner like Signature Polish
(see side note) and apply with a soft lint-
free cloth.
To bring out the natural luster of both
finishes, lightly wipe the surface with a
water-dampened microfiber cloth, followed
with a dry microfiber cloth. All work should
follow the grain direction of the finish.
Better results are obtained by keeping the
cloth in continuous contact with the metal.
Under no circumstances should you use a
metallic or highly abrasive cleaner or cloth,
as this will permanently scratch the surface.
DO NOT use abrasive cleaners on your
cooktop (e.g. Comet); they will perma-
nently scratch the surface.